Product Description
Brass bleed restrictions to press in main body or air horn for main air bleed adjustments.
OD is .120" to fit the casting.
Product Videos
Videos Hide Videos Show Videos
Custom Field
Product Reviews
6 Reviews Hide Reviews Show Reviews
-
Perfect fit
These, drill to size down channel restrictors worked great , I chucked them up in my drill and and while they were spinning I used my pin vice with a .060" drill bit and pushed it through the center hole this got me the custom size I needed ! Thanks ! Charlie
-
Air bleeds
Worked exactly like it supposed to.
-
bleed restrictions
I can depend on Quadrajet Power to have top quality QJ parts. When you need to dial in or re-calibrate a QJ, these restrictions are a must.
-
Bleed Restrictions
Have not installed these yet, but they look to be machined very well!
-
Fit great, worked perfect
great to replace incorrect bleeds or to sub into large bleed Chevy carbs. A chamfer tool really helps cut a small bevel on the end to guide it into the bore a little easier
-
Worked great
I used two pair of these as replacements in a quadrajet that's going atop a 300HP/350 in a '73 Vega. The core I used must have had the old ones removed because it shouldnt have been a large main air bleed carb. A dead blow hammer, a punch, and about 15 minutes, and both pairs were installed. Air horn ones went in easier than the main body ones. Word of caution, keep in mind they are brass, so they're soft. A brass punch is best, but if you only have steel, match the size as closely as possible and beat them in deliberately to minimize deformation
